Hi seemed like one of my pads at left half was not solid enough glued - it popped out at hot swapping. is there a chance to get a circuit diagram so I can workaround? (it’s left half the Q-button in default layout)

This made me curious. That comment and thread are about the m01. How did it solve your problem?

jesse wrote there the pin on the left should be bridged to the equivalent pins on the switches to the left and right of it and the pin on the right should be connected to the column’s test point with a 1N148 diode. it is similar to my problem only mirrored. I could measure the other keys with a vo…

Model 100 Pad popped out

Help and Getting Started

Felix (Felix) November 19, 2022, 3:31pm 2

Found this comment: Noob error replacing a switch - #6 by jesse that solved my Problem

Topic		Replies	Views
Noob error replacing a switch Hardware hacking question	6	823	May 26, 2021
Key Chatter Fix + Soldering Mistakes Hardware hacking	1	907	September 24, 2022
Dead key on Madel 01 Hardware hacking	4	62	June 24, 2026
Suggestions for fixing a blown diode connection Hardware hacking	2	581	July 8, 2021
Short circuit issue after keyswitch swap Hardware hacking	13	1115	June 20, 2018

Model 100 Pad popped out

Related topics